Sunforce Éolienne 600W Notice D'utilisation page 5

12V - 14.4V( ) or
Lead-acid batteries
15.8V( )
deep-cycle Battery
Battery Protection Voltage:
24V - 28.8V (Lead-acid batteries)
or 30V (Deep-cycle batteries)
Rated Load Current: 35A Max.
≦1400 rpm
Over-Speed Braking:
Caution: Please review the following wire gauge table to install the correct wire gauge. Sunforce
recommends these as the minimum wire sizes for optimal performance.
Always use the largest gauge wires that are practical and affordable. Local, state, and or national
electrical codes take precedence over these general recommendations.
System protection (see also included manual)
Your MPPT charge controller comes equipped with state of the art overcharge protection.
Temperature of the internal circuitry is moderated by an internal fan that is activated at 45 C(110F).
When the temperature of the MPPT exceeds 65C(150F) your MPPT will automatically shut down and
apply the braking system to your Sunforce Wind Turbine to prevent damage.
3
.1 System wiring diagrams
There are multiple options to connect your Wind Turbine dependant on your power requirements
and available components.
5