Sunforce Éolienne 600W Notice D'utilisation page 16

Reverse polarity will cause damage to both your MPPT controller and battery if not quickly remedied.
Always double check any wiring to reduce the risk of reverse polarity. Your turbine is equipped with
polarity protection to reduce the risk of damage, but it is still possible to degrade your wiring and
cause damage to the overall system.
(5) Will it hurt my Sunforce Products 600 Watt Wind Turbine to short-circuit the output?
No, the Sunforce Products 600 Watt Wind Turbine is designed to be short-circuited as a normal
shutdown procedure by a fuse. The function of the stop switch is to both disconnect the turbine from
the batteries as well as short-circuit the output of the turbine.
(6) Where can I locate tubing to make a tower?
Your Sunforce Products 600 Watt Wind Turbine is designed to make mounting as simple and
straightforward as possible. Should you not wish to purchase the custom tower kit feel free to utilize
schedule 40 1.5 inch steel tubing. This should be available through your local hardware outlet.
(7) What is the difference between copper and aluminum wire?
Generally aluminum wire is less conductive, so it must be bigger for the same amp load and resistive
losses as copper. Sunforce Products 600 Watt Wind Turbine uses copper or tinned copper for the
yaw wires.
(8) What battery should I choose for my Sunforce Products 600 Watt Wind Turbine?
There are multiple battery options in today's market– flooded lead acid, absorbed Glass mat (AGM),
gel cell and NiCad. There is no definitive choice for your alternative energy needs. Normally the
choice of battery is determined by availability and pricing. Should you have questions regarding
batteries please consult a local battery supplier. Or view: www.batterycouncil.org. The capacity of
your battery bank is determined by your use. Below is a good guideline.
• 12-volt systems – 400 Amp-hours
• 24-volt systems – 200 Amp-hours
16