Sunforce Éolienne 600W Notice D'utilisation page 19

Sunforce Products 600 Watt Wind Turbine power lines, on the radio's power lines, and on
transmission wires. Transmission lines should always be kept as far from power lines as is practically
possible. Proper grounding of the Turbine and other system components must also be observed.
(12) Will it affect the regulation of my Sunforce Products 600 Watt Wind Turbine to install an RF
(radio frequency) filter?
An RF filter should not affect the regulation of the Turbine, but any electronic devices placed in line
with the turbine must be rated for the proper current and voltage. It is best to place any line filters on
the power lines for the load device that requires it, and as close to the device as possible.
Trouble shooting
You may require an extra person to assist with these tests.
1) Remove the blade/hub from the turbine. Replace the rotor hub nut on the rotor shaft.
2) Quickly spin the rotor shaft manually with your fingers while connecting and disconnecting the red
and black wires (turbine must not be connected to batteries).
3) With the red and black wires connected to each other, the shaft should be more difficult to turn.
When the wires are disconnected it should spin freely.
Should this not be true please contact supplier or Sunforce Products.
4) With your 600 Watt Wind Turbine connected to your battery bank, use an electric hand drill to spin
the rotor shaft.
5) Below 500 RPM, the rotor should spin freely without friction.
6) At 500 RPM and above, the Wind Turbine should be charging the battery. You should feel
resistance on the rotor shaft if the shaft is not rotating; contact your turbine dealer or Sunforce
Products. Be aware your battery banks needs to be under 12V or 24V for this testing as the Turbine
needs to read a charge.
Sunforce Products warrants your product to be free from defects in material and/or workmanship for a period
of 5 years from original date of purchase. Warranty coverage is extended only to customer (original purchaser).
If product proves defective during warranty period, Sunforce Products, at its option will:
1. Replace wind turbine with new or refurbished product.
2. Correct reported problem
Customers warranty continues to be valid on repaired or replaced product from original warranty date.
Restrictions
This warranty covers defects in manufacturing discovered while using the product as recommended by the
manufacturer. The warranty does not apply to a) equipments, materials, or supplies not manufactured by
Warranty
19