Wiring Diagram - Broan ROOMSIDE Série Instructions D'installation, D'utilisation Et D'entretien

7. Connect wiring.
Connect power cable to housing with appropriate
UL approved connector (not included). Make wiring
connections as shown in "Wiring Diagram" section. Re-
install wiring panel and secure with screw from parts bag.
8. Mount fan to ceiling structure.
Mount housing to ceiling structure with standard
drywall or wood screws (not included) in locations
shown.
*
Center hole optional.
6
9. Connect 4-in. round duct.
Install blower. Finish ceiling, then
install grille.
See Steps 9 & 10 on Page 5.

WIRING DIAGRAM

DUAL CONTROL
(purchase separately)
SWITCH BOX
LIGHT
FAN
120 VAC LINE IN
Pull existing ducting through housing discharge
opening.
Attach and tape ducting to duct connector.
Push connector/ducting back through opening.
Engage tabs and secure with screw from parts
bag.
3
2
4
BLACK
WHITE
RED
GROUND
(bare)
WIRING PLATE
1
TABS
RECEPTACLE
(LIGHT)
RECEPTACLE
(FAN)
1101892D