Pair Camera With Monitor - RC Logger 89050RC Instructions D'utilisation

sub-1 firmware update
This setting enables you to update the firmware of the monitor.
Follow below steps for successful updating:
1. Prepare a microSD card and format it. Place the firmware
update (file extension: ".elf") in the root directory of the
microSD card.
2. Turn the monitor off and slide the card into the microSD
card slot (14).
3. Turn the monitor on.
4. The monitor will detect the firmware file and start the update
process. Confirm the confirmation dialogue with "Yes". The
monitor's firmware will be updated automatically.
sub-1 default setup
This setting allows you to reset your device to the factory
settings. Select "Yes"and confirm.
sub-1 memory Info
Displays the current capacities of the microSD card.
sub-1 version
Displays the installed firmware version.
sub-1 display mode
Select your preferred display mode:
- 16:9 ratio
- 4:3 ratio

15. PaIr Camera wITh monITor

"Pairing" means connecting your wireless RF (Radio
Frequency) camera to the monitor. After pairing camera and
monitor they are able to safely communicate with each other.
For successful pairing, you are required to correctly set the
channels on camera and monitor.
1. The section "Sub-1 Channel Setting" on page 16
provides you with the available settings for setting the
channel.
2. Carefully read the operating instructions that came with
your compatible RF camera. Look for descriptions on how
to set the channels.
19