Function Settings - RC Logger 89050RC Instructions D'utilisation

firmware update
default setup
memory Info
version
display mode
16
Yes
No
Yes
No
All: 0.0 MB
Free: 0.0 MB
Software Version:
16:9
4:3

13. funCTIon seTTIngs

This chapter describes the "Function" settings in more detail.
Note the following header prefixes for easier navigation:
- Sub-1 : Parent menu
- Sub-2 : Child of parent menu
> Slide the video switch
> Observe the section "Menu navigation" on page 14.
sub-1 Channel setting
sub-2 Channel switch select:
> Here you choose which channels shall be activated and be
scanned by the monitor during auto channel search.
> Uncheck/check channels which you want to include in the
search.
> If you decide to set the channels manually, check the ones
you would like to use.
sub-2 auto switch:
> If you like the monitor to search for channels automatically,
then activate the function with "On". For manual channel
selection turn the function off with "Off".
into position or .