Seiko Epson TM-P60 Manuel D'utilisation page 15

Masquer les pouces Voir aussi pour TM-P60:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
(When using the label peeler issuing mode)
3.
Peel off the first label, and press the peeler change over lever to lift the peeler
holder.
(When installing the label paper horizontally)
4.
Set the new roll paper on the inside of the roll paper cover.
Note:
Note the direction the paper comes off the roll. See illustration
(When installing the label paper vertically)
4.
Set the new roll paper in the inside of the roll paper cover. See
illustration
5.
Pull the leading edge of the roll paper. See
6.
Align the left edge of the roll paper with the edge of the cover. See
illustration
Note:
Note the direction the paper comes off the roll.
7.
Pull the leading edge of the roll paper. See illustration
8.
Close the roll paper cover.
9.
Close the peeler cover.
Note:
Removing the issued label enables the label peeler detector to detect a PAPER END and the
printer to issue the next label.
If the first label is not removed when using the label peeler issuing mode, the thickness of
the label and the backing paper overloads the peeler holder, possibly stopping the paper feed
motor.
When closing the peeler cover, make sure to close it firmly, pressing both ends.
See illustration
When tearing the backing paper, pull it in the direction of the arrow shown in the
I
illustration
paper jam.
When the label is completely fed to the peeling position, the printer goes in the label
removal waiting state, so remove the label.
When the label peeler detector detects the paper at the power on, the printer goes in the
label removal waiting state and the ERROR LED comes on. Be sure to remove the label
before powering off the printer. Otherwise, the printer goes into the label removal waiting
state when it is powered on again.
Buzzer
The factory default is set to On (buzzer sounds) to indicate the following:
Remaining battery charge is not adequate
Host disconnection
Roll paper end
Error
Transmission of status information
G
.
G
.
H
.
as you tear it. Otherwise, the backing paper may move to one side, causing a
F
.
in illustration
F
.
TM-P60 with Peeler User's Manual 9
English
in
G
.
in

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

M196c

Table des Matières