About This Document; General Safety Instructions - Franklin Electric 2803552115 Instructions De Montage Et De Service

1. About this document

• The instructions and information in this
manual form an integral part of the
equipment and describe its safe and
intended use.
• Keep this manual in the immediate vicini-
ty of the installation.
• Hand this manual to any subsequent
owner or installer.
•
apply to the equipment described in this
manual.
• Technical changes may be made without
notice in the interest of product develop-
ment.
2. Warnings notices and symbols
Warning notices
and symbols
Direct/Immediate
danger to life and/or
Danger!
Possible danger to life
Warning!
Important information.
You should observe
this information to
ensure correct and save
operation. Possible
danger of physical harm
Information!
and/or material damage
may otherwise result.
3. Safety
Observe the safety rules in this manual.
Safety measures are listed in this section.
Intended use
• The equipment described in this manual
is intended for use with a Franklin
Electric submersible motor.
•
the motor.
• Pump and motor must operate under
water only.
•
cable directives, regulations and statutory
provisions
Loss of guarantee and liability exclusion
Franklin Electric shall not be liable for the
damage resulting from any non-intended
use. The risk of such use rests solely with
the user.
Target group
Any electrical system such as described in
this manual must be installed by professional
3

General safety instructions

The following safety instructions must be
observed prior to putting the control gear
into use:
•
•
•
•
•
•
•
Meaning
•
•
health
•
and/or health.
•
•
•
4. Storage, transport and disposal
Storage
•
•
•
Transport
Observe temperature and humidity speci
-
tions during periods of transport.
(-10°C to +55°C non-condensing).
Unpacking
After unpacking, check for physical damage
that may impact on the safety of the control
gear such as a damaged enclosure, dis-
lodged cable glands etc. Observe the local
regulations and dispose of any packaging
material accordingly.
Mount the control gear in an appropriate
location, orientation and position.
Do not modify the control gear or its
electrical or mechanical connections.
Do not remove any part or parts of the
control gear.
Never install any control gear with a
known defective motor.
Remove power before working on control
Make sure that nobody can switch on
power unexpectedly while work is being
carried out.
Never work on electrical systems during
a thunderstorm.
Commissioning or testing can only be
Replace all protection and safety devices
after completing work.
Ensure that all electrical connections and
safety devices have been checked and
that all fuses and safety devices have
been set correctly before switching on.
Make sure that no danger zones are
accessible (e.g. electrical connections).
Read the pump manufacturer's commis-
sioning instructions before switching on
any control gear.
Repairs must only be carried out by
authorized professional workshops. Use
original Franklin Electric spare parts only.
Do not remove the control gear from
its original packaging until the time of
installation.
Keep this manual with the control gear
for future use.
Do not store in direct sunlight or close to
any heat source.
-
GB