EUROM SHOEDRYER 2.0 Manuel D'utilisation page 11

16. Make sure that the air around the shoedryer can circulate freely. Do not place the shoedryer too
close to walls or large objects and do not place it under shelves, cupboards, and similar.
17. This appliance is only for use in the home.
18. Do not program the shoe dryer to switch on automatically using a time clock or similar. Always
perform safety checks before using the appliance!
19. Keep the shoe dryer clean. Dust, dirt and/or deposits in the appliance are a common reason for
overheating. Make sure that these types of deposits are removed frequently.
20. Do not use any additions/accessories on the shoe dryer; they are not recommended or supplied
by the manufacturer.
21. The appliance (incl. cord and plug) may only be opened and/or repaired by properly authorised
and qualified persons.
22. Only use the shoedryer 2.0 for its intended purpose and as described in this instruction manual.
Not abiding by instructions 20, 21 and 22 may lead to damage, fire and/or personal injuries. A failure
to adhere to these rules also immediately nullifies the guarantee and vendor, importer and/or
manufacturer do not take responsibility for any of the consequences!
Description
1 - ON/OFF button & Timer button
2 – pilot light
3 – body of the shoe dryer
4 - air intake grill (back)
5 – drying hose (2x)
6 – air outlet (2x)
Switching on and operation

Remove all packaging material and keep out of reach
of children. After removing packaging, check the
appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt,
do not use the appliance, but contact your vendor for
inspection or replacement.

Place the unit straight, on a sturdy, flat and horizontal
surface. Ensure there is sufficient space at the back
side (air inlet).

Place the shoes/boots that are to be dried for the
appliance and insert the drying hoses into the
boots/shoes. However, make sure that the warm air
that is blown out is then able to escape again;
therefore the hoses must not be inserted too tightly
into the boot/shoe, otherwise the appliance may
overheat!

Check that the control button is '0' (off).

Fully unwind the electric cable and insert the plug into a suitable 220/240V socket.

By now turning the ON/OFF button anticlockwise to ON, you switch on the appliance. It will draw
in air from the rear, heat this up in the appliance, blow this out through the hoses which will dry
out the shoes/boots. During operation, the indication light will be illuminated.

You turn off the appliance by turning the ON/OFF button clockwise to '0' (OFF).
11