Rear; Initial Operation; Service And Technical Problems; Specifications - Magnat MCD 750 Mode D'emploi

REAR

1 MAINS CONNECTION
For connecting the supplied mains cable.
2 POWER SWITCH
Switches the device on and sets it in the standby mode. If the switch is set to the „OFF" position, the
device is disconnected from the mains supply.
3 ANALOGUE AUDIO OUTPUTS
RCA output jacks for connection to a hi-fi audio amplifier.
4 / 5 DIGITAL AUDIO OUTPUTS
For the connection of external devices via the optical (5) or coaxial (4) digital output
6 UPDATE
This connection is intended exclusively for system updates.

INITIAL OPERATION

• Place the MCD 750 on an even surface. Observe the relevant clearance gaps as specified under
„Important safety instructions".
• Connect an audio output (analogue or digital) to a suitable amplifier. Also refer to the operating
instructions for the device when doing this.
• Connect the supplied mains cable to the rear and then insert the other end into a 230V socket.
• Actuate the on/off switch on the rear side, the device is now in the standby mode.
• Switch on the device using the remote control or with the ON/STBY key on the front.

SERVICE AND TECHNICAL PROBLEMS

If you should encounter any technical problems, please contact your specialist dealer or
Magnat Audio-Produkte GmbH, Tel.: 02234807-0.

SPECIFICATIONS

Frequency response:
Signal to noise ratio :
Channel separation:
Output voltage:
Harmonic distortion:
Mains voltage:
Electricity consumption:
Max.
Standby
Playable formats:
Dimensions (wxhxd):
Main device:
Main device incl. operational
elements/connecting terminals:
Remote Control:
Weight:
Subject to technical change.
For further information please visit our website: http://www.magnat.de.
13
20 Hz – 20 kHz (+/- 0.5 dB)
108 dB (20 Hz – 20 kHz, A-weighted)
> 110 dB (1 kHz)
2.0 V
analogue output: < 0.005%
digital outputs: < 0.0012%
100 – 240 VAC / 50/60 Hz
30 W
<0.5 W
CD-Audio, CD-R, CD-RW, MP3, WMA
433 x 78 x 317 mm
433 x 78 x 322 mm
45 x 175 x 20 mm
3.9 kg