Product Overview; Installation - L2G BBC208S Notice D'utilisation

BACK BAR COOLER
USER & INSTALLATION GUIDE

PRODUCT OVERVIEW

Model No.
BBC208S
BBC330S

INSTALLATION

• Store the unit upright. If the unit has been stored or transported on its back, front or sides then it must be
placed upright for at least an hour before switching on.
• Place the unit on an even floor as far away as possible from any source of heat.
Note: Do not move unit by lifting either the door or door handle as this may cause damage to the
cabinet.
• Please ensure the correct aperture size is made available for this unit.
• The correct aperture size should give a gap of approximately 30 mm between the top of the cabinet
and the underside of the back bar and between the back of the unit and the wall. Poor ventilation due to
insufficient aperture size is likely to cause: reduced cooling; icing up; premature compressor failure.
Sliding door models
SPACE REQUIRED
All dimensions exclude door handle
Height
BBC208S 930 mm
SPACE REQUIRED
All dimensions exclude door handle
Height
BBC330S 1380 mm
1
Width Depth
660 mm 542 mm
Width Depth
660 mm 542 mm
L2G SAS 17, AVENUE DU 24 AOÛT 1944 - 69960 CORBAS
: +33(0)4 72 23 23 98 +33(0)4 72 23 23 99
Article description
Sliding two door back bar cooler
Sliding three door back bar cooler
UNIT DIMENSIONS
All dimensions exclude door handle
Height
BBC208S 900 mm
UNIT DIMENSIONS
All dimensions exclude door handle
Height
BBC330S 1350 mm
www.L2Gfrance.fr
Width Depth
600 mm 512 mm
Width Depth
600 mm 512 mm