Outwell TORNADO PUMP Mode D'emploi page 3

ELECTRIC AIR PUMP
Automatic
charger
Charger
(EC or UK standard)
DC socket
READ FOLLOWING INSTRUCTIONS AND WARNINGS BEFORE USE
1 IMPORTANT
• Power supply must be AC 230V or DC 12V (automotive charger). Never use the
pump when it is being charged. Charging by 230V transformer, red light on the
transformer will glow when the charger is connected properly. It takes about
15 hours to fully charge the battery. (Allow the battery to fully discharge before
re-charging) You may charge the pump by the 12V transformer. Red light on the
transformer will glow when charger is connected properly. When pump is fully
charged, the red light will turn to green.
• This is a high volume low-pressure pump. It is intended to inflate/deflate items,
such as inflatable boat, air mattress, etc. This pump is not designed for continuous
use. Extended operation over 30 minutes can overheat and damage the pump.
• Keep the air pump out of the reach of children under 3 years old.
• The air pump must be used with the recommended transformer.
• The transformer is not a toy.
• Do not obstruct the inflation/deflation port and keep them ventilated at all time.
For fast inflation and to shorten the motor's working time, always use the suitable
adapter according to the size of valve on inflatable item.
2 WARNING
• Any damage visible on cord immediately contact qualified electrician to repair or
replace the damaged cord.
• Carefully follow the instructions on inflatable item when inflating. Never exceed
recommended pressure, otherwise, serious injury might be caused by the
bursting item.
• Never leave pump unattended while in use.
• Do not keep/use the pump in wet conditions.
• Never allow sand, small rocks, etc. to be sucked into inflation/deflation port when
using the pump.
• Never look inside or point the inflation/deflation port toward your eyes when the
pump is turned on.
• When the equipment has been worn out and can not be used anymore unplug
the power supply and dispose properly according to the local regulations.
Switch
Inflation port
Deflation port
Connection I
Connection II
2
3 TO INFLATE ITEMS
• Choose nozzle which fits valve
of inflatable item
• Insert the nozzle into the valve
• Switch on to inflate/switch off to stop.
(On the switch the symbol "ON means
switched on , "OFF" means switched off )
• The valve of inflatable item should not be
obstructed; otherwise, the pump could
overheat and get damaged
• Never use the deflation port when inflating
an item
• On large items like inflatable boat and king-
size mattress, the pump should fit directly to
the valve for fast inflation. Use the appropriate
nozzle for small valves on single–size air
mattress, etc
4 TO DEFLATE ITEMS
• Choose nozzle which fits valve
of deflatable item
• Insert the nozzle into the valve
• Open the valve of inflatable item
• Insert the nozzle into the valve
• Switch on for deflation/switch off to stop.
(The symbol "ON" on the switch means
switched on, "OFF" means switched off )
• The valve of inflatable item should not be
obstructed; otherwise, the pump could
overheat and get damaged
• For small valve of inflatable item pinch the valve
with your fingers to allow the air to escape
3