AEG 4Safety PLUS DB52 Série Mode D'emploi page 22

Troubleshooting
Problem
GB
Soleplate is not heating even though iron
is turned on.
Iron does not produce steam.
Spray function does not work.
Steam jet and vertical steam jet function
does not work.
Brown streaks come out of the soleplate
while ironing and stain the linen.
22
Possible cause
Connection problem
Temperature control is in MIN position.
Not enough water in tank.
Steam control is selected in non-steam
position.
Selected temperature is lower than that
specified to use with steam.
Not enough water in tank.
Steam jet function was used very frequently
within a short period.
Iron is not hot enough.
You have used hard water, which has caused
scale flakes to develop in the water tank.
You have used chemical descaling agents.
Fabric fibres have accumulated in the holes
of the soleplate and are burning.
Fabrics might not be properly rinsed or
the garments are new and have not been
washed before ironing.
Solution
Check main power supply cable, plug
and outlet.
Select adequate temperature.
Fill water tank (see "Getting started", no 2).
Set steam control between positions of
minimum steam and maximum steam
(see "Ironing chart").
Increase temperature to at least
Fill water tank (see "Getting started", no 2).
Put iron on horizontal position and wait
before using steam jet function.
Adjust the proper temperature to steam
ironing (up to ). Put iron in vertical
position and wait until temperature
indicator light turns off.
Use the self-clean function one or more
times.
Do not use any descaling agents.
Use the self-clean function one or more
times. Clean the soleplate with a damp
soft cloth.
Please rinse the laundry properly again.
.