General Remarks - Thule QuickFit 307056 Manuel D'utilisation

EN
Warranty
-
Read the installation instructions carefully. Wrong installation, use or repair voided warranty. If
recovery is needed, consult a dealer.

General remarks

-
Check if the supplied Thule QuickFit suits the type, length, and the projection of the canopy.
Check that the height of the tent matches the mounting height of the caravan rail (height
between the ground and the rail where the tent slides in).
-
Make sure the vehicle is leveled.
-
The sun can affect colors depending on usage.
Steps 1 to 7
1. Open the awning maximal. Use a Strap kit and a tension rafter on the awning before tightening the
tent completely.
2. Slide the tendon of the tent trough the rail that is located under your awning. Use the pull-tab for
better grip. For easy installation, do this with two people.
3. Slide the black pieces (with the hole) in the lead rail of the awning and the pieces with a hook on
the straps of the tent.
4. Hook the tent to the front profile using the mounting pieces. Use both hands to clamp the tent .
Put the tent leveled, but the awning under a slight angle for proper water drainage.
5. Unfold the fiberglass poles and slide them into the provided channels. Fold the sticks in place, but
do not bend more than necessary. Treat the tent poles with care while dismantling the tent.
6. Fix the Thule QuickFit with pegs and pins, but always with closed zippers. Start at the back of the
vehicle , proceed to the front, then put tension on all the walls and finish with two tensioning
ropes at the front. Use proper pegs depending on the type of soil.
7. Assemble the windslip through the caravan rail. Attach the wheel cover using the screws (for
walls with wood base) or rivets (for walls with foam base). Close the holes with silicone to avoid
water infiltration.
Safety
-
Put one side of the awning lower so that when it rains the water can drain.
-
When wind reaches 6 Bft. please store the tent and close the awning.
-
Don't place heat sources near the walls or the roof.
-
Avoid covering the refrigerator grille with the tent.
-
Use a Strap kit and a tension rafter on the awning before tightening the tent completely.
Maintenance
-
Make sure that before installing the tent, the connections to the vehicle are sufficiently clean .
Sand, dust or dirt could cause damage to your vehicle. When you stay for a long period, clean the
tent a few times.
- Ensure that there are no hard objects on the windows of the tent during folding. This is to prevent
impressions on the window.
- Let the tent dry thoroughly before storing.
- Use pure water or a dry brush to clean the tent.
- Condensation inside the tent is normal. Ventilate the tent adequately.
12 SLW900-03