Fulbat FPG12-100 Instructions De Montage page 6

FITTING
(1) In order to optimize the life and power of your battery, an initial charge is highly
recommended.
(2) Always fit in accordance with manufacturer's directions.
(3) Positive and Negative terminals must be connected to their correct terminals.
CHARGING
(1) Never exceed a charging current greater than 50% of the battery capacity.
Charging too quickly or overcharging can cause damages.
(2) If the battery becomes hot to the touch, stop the charging and allow it to cool down
before recharging.
(3) Always remove the battery prior to charging.
(4) Charge the battery with a battery charger suitable for this size/type of battery
with an output power of 1/10th of the battery's rated capacity.
(5) Let the battery settle for 1 or 2 hours after charging before checking the voltage. If the
voltage is less than 12.8 volts, an additional charge is necessary.
MAINTENANCE
(1) As this battery is fully sealed and activated at the factory, there is no maintenance by way
of topping up fluid levels.
This is the reason why one must never attempt to open this battery.
(2) If this battery has not been used for a quite long time, check the voltage and recharge as
required and described in the ''Charging'' section.
(3) Keep the connecting poles clean and securely fastened.
6