IARP A+660 N Instructions D'emploi Et D'entretien page 15

CLEANING (A+660 P)
ATTENTION! BEFORE CLEANING, PLACE THE REFRIGERATOR OUT OF SERVICE
BY DISCONNECTING THE POWER PLUG.
For the tank cleaning operations, proceed as follows:
1. Put the product in a special refrigerated container at the same temperature and remove the shelves.
2. Leave the door open and wait until the internal temperature matches the ambient temperature.
3. Clean the surfaces with a cloth, using neutral PH detergent, rinse and dry.
4. Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent and fresh water.
5. Then turn unit back on and wait for it to reach the correct temperature before refilling it.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
Warning! Do not use water jets for cleaning: this can damage the electrical parts.
Warning! Do not use mechanical appliances or other means to speed up the defrosting process,
other than those recommended by the manufacturer.
DEFROSTING (A+660 P)
Defrosting is automatic. When the appliance is subject to numerous or close openings of the door, or when
the environmental conditions for temperature and humidity are high, ice can form inside the tank.
In this case, proceed to defrost manually as follows:
ATTENTION! BEFORE CLEANING, PLACE THE REFRIGERATOR OUT OF
SERVICE BY DISCONNECTING THE POWER PLUG.
1. Put the product in a special refrigerated container at the same temperature and remove the shelves.
2. Leave the door open and wait until the internal temperature matches the ambient temperature.
3. Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent and
fresh water.
4. Then turn unit back on and wait for it to reach the correct temperature before refilling it.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
Warning! Do not use mechanical appliances or other means to speed up the defrosting process,
other than those recommended by the manufacturer.
DEFROSTING AND CLEANING THE TANK (A+660 N)
ATTENTION! BEFORE CLEANING, PLACE THE REFRIGERATOR OUT OF
SERVICE BY DISCONNECTING THE POWER PLUG.
To always get the best performance out of the refrigeration system, a manual defrost is recommended when
the thickness of the frost in the tank is greater than 5 mm; proceed as follows:
1. Remove the product from the tank and store it in a cooler at -18°C.
2. On negative models, pour a basin of warm but not boiling water inside of the tank, placing it on a sheet
of cardboard, close the door and wait for about half an hour.
3. Clean the surfaces with a cloth, using neutral PH detergent, rinse and dry.
4. Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent and
fresh water.
5. Then turn unit back on and wait for it to reach the correct temperature before refilling it.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
Warning! Do not use water jets for cleaning: this can damage the electrical parts.
Warning! Do not use mechanical appliances or other means to speed up the defrosting process,
other than those recommended by the manufacturer.
-15-