IARP A+660 N Instructions D'emploi Et D'entretien page 13

INSTALLATION
Appliance suitable for packaged foodstuff preservation.
This appliance is intended for use in ambient temperature up to 40°C.
After unpacking, thoroughly clean the entire bench with warm water and 5% mild soap and then
dry it with a soft cloth.
The distance from the wall should be at least 10 cm.
Adjust the feet with respect to the support plane of
the rollers.
Position the appliance on a level surface away from
heat sources that is not exposed to sunlight.
It is essential for the condenser unit to be able to
exchange air freely; therefore, the air grills must not
be obstructed by boxes or anything else.
Do not position the appliance outdoors or expose
it to rain.
Do not use electrical appliances in the refrigerated
compartment.
The appliance is not suitable to withstand spills
of liquid on top of it.
Therefore, do not rest or place containers with
liquids immediately above the refrigerated cabinet.
Install and position the appliance so that the power
plug is easily accessible.
THE APPLIANCE IS NOT SUITABLE FOR
INSTALLATION IN AREAS WITH DANGER
OF FIRE OR EXPLOSION OR EXPOSED TO
RADIATION.
The external environmental conditions for the
appliance to run smoothly are indicated on the
rating plate.
During transport, insert a suitable wooden block under
the door to prevent possible sagging of the frame.
120°
WARNING!!
TO AVOID DAMAGING THE
MECHANISM, RESPECT THE
MAXIMUM DOOR OPENING
ANGLE.
-13-
10 cm