HI-Q TOOLS ROCKER FRONT WHEEL STAND
Ord. Nr. 60150700050
CONTENT
1 front wheel stand base (bottom)
1 front spar
1 front wheel retaining plate V shaped
2 bearing bolts
2 safety splints
1 rocker one piece
4 screws with dowels to fi x on the floor
2 screws incl. self-locking nuts and washers
The HI-Q TOOLS rocker front wheel stand helps to secure the motorcycle in the garage, on
the lifting platform or during transportation on e.g. a surface of a trailer. It holds the mo-
torcycle safely in a vertical position, after the front wheel is rolled over the rocker and stands
safely in the front retaining plate. Appropriate for all tires with a size of 13-21 inch and a tire
width of 90-130 mm. Assemble the front wheel stand base (bottom) with the front spar and
the enclosed screws incl self-locking nuts und washers. Make sure the tube of the front spar
lies correctly in the supports of the base and the srews are tightened fi rmly. The ground fi xing
(hole) of the front spar should point to the front. Now assemble the front wheel retaining
plate incl. bearing bolt. Note: for smaller tires use the front position, for larger tires the rear
position. Then fi x the rocker with the bearing bolt and the safety splint on the base.
SAFETY NOTES
1. After assembly and before use check again all the screw connections and all the safety
splints for fi rm and secure hold.
2. Use the mini lifting table only on solid, plane ground (e.g. asphalt, concrete, stone). Never
use loose ground as surface .
3. Never sit on the from the HI-Q TOOLS rocker front wheel stand put motorcycle.
4. If you use the HI-Q TOOLS rocker front wheel stand on a lifting platform or a trailer/surface, it
has to be screwed fi rmly in the corresponding position over the prevued holes on the rocker.
In addition, the motorcycle has to be fi xed with lashing straps.
This product is for universal use without specifi c detailed vehicle allocation, it is important
to convince yourself before fi rst use if you can use it approprately and without problems on