HumanTechnik MF-1 Mode D'emploi page 7

BA-MF-1_0605 26.06.2005
Congratulations on purchasing the
Flash Module MF-1. You have selec-
ted a modern and reliable system.
With the Flash Module MF-1 you can
extend every unit that has a connec-
tor socket (3.5 mm jack) for the
vibrating pillow with a flash signal.
Standard components
Please check if all listed items are
included:
- Flash Module MF-1
- Connecting cable
- 9 V-power supply unit
- Warranty card
Installation
Attach the connecting cable to one
of the two connector sockets for the
signal source at the back of the
Flash Module MF-1. Plug the other
end of the cable into a unit with a
connector socket for a vibrating pil-
low (e.g. vibrating clock VC-10).
Plug the 9 V-power supply unit in the
respective socket at the back of the
Flash Module MF-1.
17:55 Uhr Seite 7
Note
A vibrating pillow or another module
(e.g. Acoustic Module) can be
plugged into the empty connector
socket at the back of the Flash
Module MF-1.
Signalling
Upcoming signals (e.g. wake-up
alarm, lisa alarm) are signalled by
very bright flashes.
Special features
Power failure backup/:
with a 9 V battery
Battery operation (not included)
The acoustic module MA-1 can also
be operated on just a 9 V battery
English 7