purline PRLA5M Manuel D'utilisation page 9

By taking these safety measures for reference, mark
with the pencil the location of the higher hole of the
first wall bracket.
You are useful of the guide paper to mark the higher
hole of the second wall bracket by tightening paper
well for good distance. Attention to be quite
horizontal. Repeat the same operation for the lower
holes of the two wall brackets.
- Once the 4 marked holes necessary to fix the
bracket, you can bore. Once the holes of the wall
bored, insert there the ankles in figure provided with
the appliance (small plastic bag).
- Then you can fix, using the large screws, the higher
and lower holes of the wall bracket. Do not forget to
put a disc (small plastic bag) between the screw and
the bracket.
- Once the wall brackets firmly fixed at the wall, you
can suspend the appliance by the panel holes located
at the back of the heater, those marked of a red arrow.
WARNING: If you choose wall mounted, you should
pay attention to your wall, please be sure the wall is
made of anti-burning materials, or bearing high
temperature, otherwise we do advise you to choose
Portable installation.
Operating instructions:
This unit is fitted with pilot lamp, switch and thermostat.
• Pilot lamp: This lamp lights on to indicate that the
unit is producing heat, and it lights off when the
appliance is no longer producing heat.
• Switch: This knob is used to turn the unit ON/OFF
and to select one of two heating power levels (low or
high). It has three positions: Position 0 means OFF;
Position 1: low speed for heating; Position 2: high
speed for heating.
• Thermostat: The thermostat is the device that
regulates the room temperature that you have
selected. To set the thermostat, plug the unit in and
switch it on. Then turn the thermostat control
completely to the right. Once the desired temperature
has been obtained, slowly turn the thermostat control
in the opposite direction (left) until the pilot lamp
lights off. Keeping it in this position the appliance
itself will automatically regulate the selected room
temperature.
Maintenance:
Whenever the appliance is to be handled, the plug should
be removed from the electrical socket with the switch in
OFF position: 0 and never by pulling the power cord.
Keep the air passage grille clean.