Important Safety Information - Abus TVCC34000 Manuel Utilisateur

Important safety information

All guarantee claims are invalid in case of damage caused by non-compliance with
these operating instructions. We cannot be held liable for resulting damages.
In case of material or personal damage caused by improper operation or non-
compliance with the safety notes, we cannot be held liable. All guarantee claims are
invalid in such cases.
The following safety information and hazard notes are not only intended to protect your health, but
also to protect the device from damage. Please read the following points carefully:

There are no components inside the product that require servicing. Opening or dismantling the
product invalidates the CE certification and guarantee claims/warranty.

The product can be damaged if it is dropped, even from a low height.

This device is designed for indoor use.

Install the device so that the image sensor is not subjected to direct sunlight. Pay attention to the
installation instructions in the corresponding chapter of these operating instructions.
Avoid the following adverse conditions during operation:

Humidity that is too high

Extreme heat or cold

Direct sunlight

Dust or flammable gases, vapors, or solvents

Strong vibrations

Strong magnetic fields (e.g. next to machines or loudspeakers)

The camera must not be installed on unstable surfaces
General safety information:

Do not leave packaging material lying around. Plastic bags, sheeting, polystyrene packaging, etc.,
can pose a danger to children if played with.

The surveillance camera contains small parts which could be swallowed, and should be kept out of
reach of children for safety reasons.

Do not insert any objects into the device through the openings.

Only use replacement devices and accessories that are approved by the manufacturer. Do not
connect any non-compatible products.

Please pay attention to the safety information and operating instructions for the other connected
devices.

Check the device for damage before commissioning. Do not put the device into operation if you detect
any damage.

Adhere to the operating voltage limits specified in the technical data. Higher voltages could destroy
the device or the IR LEDs, or pose a health risk (electric shock).
When installing the device in an existing video surveillance system, ensure that all devices are
disconnected from the power supply and low-voltage circuit.
If in doubt, have a specialist technician carry out assembly, installation, and connection of the
device. Improper or unprofessional work on the power supply system or domestic installation
puts both you and other persons at risk.
Connect the installations so that the power supply circuit and low-voltage circuit always run
separately from each other. They should not be connected at any point or be able to become
connected as a result of a malfunction.
15