geo-FENNEL FKL 55 Mode D'emploi page 23

EN
Display - does not flash
The laser is set up high on the left side but is still within the tolerance.
Display
The laser is perfectly levelled; most accuracte performance.
Display - does not flash
The laser is set up high on the right side but is still within the tolerance.
Display - FLASHES
The laser is out of tolerance on the rigtht side - correct the set up.
GRADE SETTING
Grade setting range: -20 % ~ + 30%
Power on the FKL 55 (Green) and press the SET button to select the grade setting.
Display indication: "+00.000 %" .
Select all digits for the grade setting with the button SET.
With the buttons 2 (up/down) the grade values can be set.
Lowest digit: 0
Maximum digit: 9
When the cursor is on the sign it can be changed from "+" to "-" with the buttons 2.
Slow pressing = slow setting of the grade values
Continuous pressing = quick setting of the grade values
When the grade values required have been set press the ENT button to confirm.
When the laser levels the grade symbol is flashing. When the self-levelling procedure has been com-
pleted the flashing stops.
Pressing both arrow keys 2 will re-set the grade value to zero again.
ADVICE - to accelerate the change of the grade setting:
Confirm the change of the grade setting (i. e. from 4 % to 15 %) with the button ENT and power off
the laser. Then, power on the laser again and now the laser aligns faster to the new grade value in the
coarse mode.
23