Drive Medical 15300 Guide D'assemblage page 14

or plug, if it is not working properly, if it has been
dropped, damaged, or dropped into water. Return the
bed to a service center for examination and repair.
On Full Electric beds, the Hi/Lo crank MUST be
removed before the bed is used. Failure to remove the
crank may cause damage or personal injury.
Refer servicing to qualified personnel only. Ground-
ing reliability depends upon a properly grounded wall
outlet.
The pendant and power cords must be routed and
secured properly to ensure that the cords DO NOT be-
come entangled, pinched and/or severed during opera-
tion of the electric bed.
Unplug from the outlet before servicing.
Unplug the power cord from its power source before
performing any maintenance on the manual/electric
bed. DO NOT unplug the power cord from the junc-
tion box. Damage to cord will result.
Use caution when disconnecting the pendant. DO
NOT press pendant buttons.
When bed is not to be used for an extended period,
unplug electric bed from the wall outlet.
When using an extension cord, use only a three wire
extension cord having at least 16 AWG (American
Wire Gauge) wire and the same or higher electrical
rating as the device being connected. Use of improper
extension cord could result in a risk of fire and elec-
tric shock. Three to two prong adapters should not be
used. Use of three prong adapters can result in improp-
er grounding and present a shock hazard to the user.
When using nasal or masked type oxygen administer-
ing equipment, the oxygen or air tubing MUST be
routed and secured properly to ensure that the tubing
does not become entangled and/or severed during nor-
mal operation of the bed.
DO NOT use near explosive gases.
Possible fire hazard when used with oxygen adminis-
tering equipment other than nasal or masked type.
Use masked or nasal type oxygen administering equip-
ment only in conjunction with this bed. The use of
ANY other type of oxygen administering equipment
can result in a fire hazard.
Before connecting/disconnecting the connections at
the junction box, make sure the cable lock is removed
by lightly depressing on the end tabs and lifting. After
connectors are plugged in, route all cables into the
cable lock slots and snap the cable lock in place. When
installing any connectors into the junction box, be sure
the cable lock is secure after installation - otherwise,
injury or damage may occur.
DO NOT force the connector into the junction box,
otherwise - injury or damage may occur.
DO NOT unplug power cord from junction box.
DO NOT unplug power cord from motor housing.