Wall Mounting Warnings; Basic Operation; Remote Control Via Tablet Pc Or Smartphone Application - VESTEL EVC02-AC22 Série Manuel D'utilisation

WALL MOUNTING WARNINGS

• Read the instructions before mounting your
charging station on the wall.
• Do not install the charging station on a ceiling
or inclined wall.
• Use the specified wall mounting screws and
other accessories.
• This unit is rated for indoor or outdoor
installation. If this unit is mounted outdoors,
the hardware for connecting the conduits to
the unit must be rated for outdoor installation
and be installed properly to maintain the
proper IP rating on the unit.

BASIC OPERATION

VESTEL Electric Vehicle Charger (EVC) is
designed to charge plug-in electric vehicles (PHEV)
and battery electric vehicles (BEV) with Type 2
socket compatible cable on charging station side.
Please read important safety warnings and
instructions carefully before operating the EVC.
Button Functions
Start / Stop Charging :
Short Press
Button Light Color
Indications
Ready
Charging : Blinking Blue
Fault
Ventilation Required Mode:
Blinking Red
Waiting for EcoTime:
Blinking Blue and Red
(WiFi equipped models)
The VESTEL EVC has a button serving START /
STOP functions and contains LED type illuminated
status indicator. (Button functions needs an
authorization with a defined ID card for models with
RFID card reader.) Button functions and
corresponding button light color indications are
given above.
At the start-up, please be sure of that Blue LED is
on. If the LED is steady Red, please check
troubleshooting section and do not connect any
charging plug to the VESTEL EVC.
Connect the charging plug to the EV and then to the
EVC. VESTEL EVC waits until the user pushes the
Start button. The charging session starts
: Steady Blue
: Steady Red
English - 3 -
immediately.
Before removing the charging plug, STOP charging
(press button during charging). The charging plug
is always locked to socket outlet before starting to
charge to prevent arcing and theft.
During charging mode, if the button LED is blinking
red, your car is in ventilation mode because of
increased ambient temperature. In this state, Vestel
EVC disconnects power supply to the car.
Remote Control via Tablet PC or
Smart Phone Application
(WiFi Equipped Models)
Vestel EVC remote control application controls EVC
and displays charging parameters.
Following steps explain how to install the
application and how to configure Wi-Fi module of
product.
1- Download Vestel EVC application from Google
Play Store to a smart phone or tablet and create
new user profile by following steps as shown in
Figure 1,2 and 3.
Figure.1
Figure.2