HAIRCUT TH33 Guide De L'utilisateur page 17

Electrical hazards
Use only the peripheral elements supplied (power pack, charging
base, clipping accessories, etc.) or those available from the
importer or its after-sales service.
Regularly check the condition of the electrical lead connecting the
power pack to the mains supply. If the lead shows any signs of
damage, stop using the clippers immediately. Contact the dealer or
his after-sales service to obtain a replacement lead.
The electrical lead must always be fully unrolled when it is
connected to a power socket. Never pull on the lead to unplug it.
The charging base must be placed on a stable, clean surface. The
charging base and the power pack must be placed well away from
any source of heat (radiator, sunlight, etc.) and in a dry area away
from any water or damp.
In the event of failure of the power pack or the charging base, they
must be replaced by a model that is identical in all respects.
Make sure that the power supply voltage corresponds to the voltage
marked on the power pack body and the charging base.
Never try to open the batteries, because they contain chemicals
that are hazardous for humans, animals and nature in general. In
the event of any leakage from the batteries, avoid all contact with
the skin, wash any affected areas with running water for about
twenty minutes and see a doctor immediately. Use paper towels or
a dry cloth to clean the clippers and contact the dealer to obtain
replacement rechargeable batteries.
Never bring the clippers, the power pack, the charging base or the
electrical lead into contact with water or excessive damp; if this
occurs, contact the importer without trying to switch the clippers
on; there is a considerable risk of electrocution. Never use these
clippers with wet hands. Always store the clippers in a dry place.
17