Hach ORBISPHERE 51 Série Manuel D'utilisation Simplifié page 9

1-3
1. Cut an opening in the panel to accommodate the bracket frame provided.
2. Install the provided frame in the opening.
3. Fold the 6 tabs over the panel lips, using adjustable joint pliers.
4. Slide the instrument in the bracket frame. The instrument should go over the four "T" pins.
Rotate the 4 fast locking screws on both sides of the front panel and slide it in.
5. Rotate the 4 fast locking screws 1/4 turn twice in the lock direction as indicated on the side of
the front panel. This locks the instrument in place on the four "T" pins.
6. To access the connections inside the instrument, remove the instrument housing (six screws on
the back panel, and slide the housing back out)
7. Pass the cables through the housing, then through the cable gland (if applicable) and then
perform the connections as detailed below.
4-5 6-7
English 9