Warm Tech PR1501 Instructions D'origine page 25

Ⅳ Ⅳ Ⅳ Ⅳ . HOW TO INSTALL
(The product has tow installation methods:Desk-top and wall mount)
1.Free standing installation:
First, take the heater out the package and place it upside down on soft
surface. Second, take four screws from the accessories(two screw for
each castor, parallel the bevel of castor bracket to the bevel of the heater,
if installed reversely, the screw cannot be revolved in.)and aim them at
the taps to tighten them. Third, Then just upright the heater and put it
into use. You may refer to the following figure.
2.Wall mounting:
First,use an electric drill to drill four holes on the wall. Diameter and
depth for the drilling holes , you can find the distance between
the four holes .
Second, insert the plastic bulged screws into the drilling holes, then lat
the screws through the hooks and aim them at the holes,fix the hooks on