Xo XOI3315S Notice D'utilisation page 12

For all measurements relating to the cooker hood, please refer to Fig.2.
Before fixing the cooker hood to the lower part of the cabinet, the following steps should
be performed:
1. Remove the 4 screws E fixing the two cooker hood brackets H (RHS and LHS) in place
as indicated in Fig.4A.
2. Remove the brackets H as shown in Fig.4B.
3. Make sure the thickness of the cabinet falls within the range of values listed in
Fig.4C.
Fit the cooker hood in the cabinet (Fig.8) and make sure the 4 springs are fixed in place
well. Fix the cooker hood to the cabinet securely by using a screwdriver to tighten the
screws M until the appliance is flush with the cabinet (Fig.5). Place again the 2 brackets
H (right and left) of the hood and fix them with the 4 screws E (Fig.6 - Fig.7).
When installed in this way the appliance discharges fumes outside, either through a
perimeter wall or existing ducting.It is therefore necessary to purchase a non-flammable
air exhaust tube A (not supplied) which complies with all current legislation and connect
it to flange B (Fig.3).
B
Fig.4
B
E
Min - 0-1/2"
Max - 1-0/16"
E
- 12 -
E
A
F D
C
H
B
F