Triton SJA200 Instructions D'utilisation Et Consignes De Sécurité page 7

4. Rotate it 180 degrees
and re-insert it into the
tracks.
• Whenever clamping
objects with the moving
jaw reversed, ensure
the workpiece sits
down onto the sliding jaw, and is parallel to
it. Avoid clamping workpieces at the top of
the jaws (with a gap between the workpiece
and the base of the moving jaw) as excessive
pedal pressure could damage the unit.
• When clamping large or heavy materials,
provide outboard support (such as a Triton
Multi-Stand) to prevent Superjaws from
tipping over.
Clamping workpieces up to 956mm can
be achieved by removing the jaw facings
(see page 8).
USING AS AN ANVIL
The fixed jaw is
sufficiently robust to be
used as an anvil for strip
metal work.
Do not use the moving
jaw as an anvil. You
could damage it.
For thicker materials we
recommend the use of the
optional Engineer's Jaws
(part no. SJA470).
USING AS A PRESS
When the lock /
release switch (13) is
in the release position
Superjaws can be used as
a press.
SJA200 Manual_new.indd 7
With each full stroke of the foot pedal, the moving
jaw will advance about 25mm.
GENERAL OPERATING ADVICE
When working along the line of the jaws, place
your foot on the foot plates (7) to prevent
Superjaws from moving.
Ripping A Plank
1. When ripping a plank,
stop your cut before
reaching the jaws.
2. Remove the workpiece
and re-clamp with
sufficient amount of
the cut beyond the
jaws, so that you can
drop in your saw to
recommence your cut.
3. Before clamping, insert
a spacer slightly thicker
than your saw cut, at
the jaw area, to keep
the cut open.
Clamping Square Tubing
It is easier to hacksaw
square tubing or similar on
the diagonal.
Use the V-grooves in the
urethane jaws to securely
hold your material.
Sharpening Chainsaws
Superjaws makes an ideal
clamp to hold a chainsaw
or Triton Chain Blade while
sharpening the teeth.
If sharpening a
chainsaw use two
wooden blocks, either side
of the bar, to ensure the clamping jaws are clear
of the chain, which can then be rotated as each
tooth is filed.
GB
Operation
7
1/2/10 17:26:16