Triton SJA200 Instructions D'utilisation Et Consignes De Sécurité page 5

SETTING UP
1. With Superjaws placed
upside down on the
ground, loosen the rear
leg locking knob (5) and
slide the rear leg from
its storage position.
Pivot the leg just clear of the front face. Slide
it all the way forward then lift and slide it fully
into its housing at the
rear. Tighten the knob.
2. Raise the foot pedal
(8) until it "clicks" into
position.
3. Pivot the front legs (9)
out as far as they will
go then turn the front
leg locking knobs (11)
clockwise until the
rounded section of the
knob tightens onto the
leg housing, as shown.
Several turns may be necessary on initial
set-up until the clamps tighten into place –
a half turn is all that is required to release the
legs when folding.
4. Turn the Superjaws
upright and recheck
that all legs are locked
firmly in position.
SJA200 Manual_new.indd 5
5. Rotate the moving jaw
locking tab (3) to the
horizontal position and
Superjaws is now ready
for use.
FOLDING
Folding is the reverse
procedure of above.
Ensure that:
• The lock / release
switch is in the
"unlock position".
• The foot pedal locking
latch (10) is used to
release and fold the
foot pedal.
• The moving jaw
locking tab (3) is in the
"vertical" position to
prevent the jaw from
sliding out
• The rear leg is engaged
fully into its housing
and the rear leg locking
knob (5) is tightened
firmly.
When in its folded
position the rear leg
becomes a carrying
handle, to aid in
transportation.
GB
Setting Up
5
1/2/10 17:26:15