1. ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit Fig.1.
(1)
Monitor.
(7L) Top focus bar, left.
(7R) Top focus bar, right.
(15L) Bottom focus bar, left.
(15R) Bottom focus bar, right.
(21) Main post.
(22) Bottom post cover.
(45) Pedal left foot.
(45) Pedal right foot.
(47L) Left footrest.
(47R) Right footrest.
(51) Bottom cover, left foot.
(51) Bottom cover, right foot.
(54) Bottom cover.
(66) Rear
stabiliser
adjustable feet.
(101) Main body.
(105) Front stabiliser bar with wheels.
(112) Handlebar tube.
(142L) Bottom trim covers, left and
right. (L) for the knuckle joints on the
focus bars.
(142R) Bottom trim covers, left and
right (R) for the knuckle joints on the
focus bars.
G2351 :
(8L) Focus bar spindle covers (L).
(8R) Focus bar spindle covers (R).
(18F ) Monitor front cover
(18B ) Monitor back cover
(116 ) Adapter
Fig.2 - . NUTS & BOLTS
(9) Screws M8x20 .
(10) Flat Washer 8.
(13) Spring washer 8 .
(14) M8x20 screws .
(43) M10 Nut
(44) Washer 10
(46) Screw M10x78
(48) Screw M6x55
(52) Washer
(67) Screw
(89) Spring washer 6
(90) Knob
(91) Washer 6
Allen wrenches 5mm
Mixed Key.
2. FITTING THE STABILISER
BARS.-
Bring the front stabiliser bar with
wheels (105) to the main body (101)
positioning the wheels at the front of
the unit, Fig.3, insert screws (67), fit
the washers (13) and the corrugated
washers (10). Use the 5mm Allen key
to tighten securely.
Take the rear stabiliser bar with
bar
with
adjustable feet (66), Fig.4, insert the
bolts (67); fit the washers (13), the
corrugated washers (10) and tighten
securely.
3. FITTING THE BOTTOM
POST COVER.-
Take the main post (21) and insert the
bottom post cover (22) in the direction
of the arrow, Fig.5.
4. FITTING THE MAIN POST.-
Once the bottom post cover is fitted,
remove the screws (9) and washers
(13) and (10) from the bottom of the
main post (21).
Bring the main post (21) up to boss on
the main body (101), Fig.6.
G2350. Unfasten the screw (129) at the
back of the tension controller (127), fit
the tension controller (127) onto the
main post (21).
17