Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Insert the bottom of the side trim covers behind the oven vent.
A
Right side front view shown
A. Oven vent
B. Right side trim cover
7. Tilt in the control panel against the side trim cover and replace
the lower screw on each side of the control panel. Do not
overtighten screws.
4
B
Install Electric Built-in Single Oven, Double
Oven and MWO/Combination Oven
1. Using 2 or more people, push against the seal area of the
front frame to push the oven into the cabinet until the back
surface of the front frame touches the front wall of the
cabinet.
2. Securely fasten oven to cabinet using the #8–14 x 1" screws
provided. Insert the screws through hole in the side trim
cover. Do not overtighten screws.
3. Follow the oven Installation Instructions to complete
installation.
NOTE: If the built-in oven was not installed into the cabinet,
read the "Electrical Requirements" and "Electrical
Connection" sections, along with all other sections of the
Installation Instructions, before installing the oven.
4. Reconnect power.
5. The display panel will light briefly, and "PF" should appear in
the display.
6. If the display panel does not light, reference the "Assistance
or Service" section of the Use and Care Guide, or contact the
dealer from whom you purchased your oven.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in microwave oven spacer kit.
Publicité
Table des Matières
