Installation Instructions; Install Side Trim Cover Kit - Whirlpool W10536160 Instructions D'installation

Follow the instructions below to install the Side Trim Cover Kit on
a built-in oven.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Remove the oven door(s). For more information, see the
"Remove Oven Door" section in the oven Installation
Instructions. If the built-in oven is already installed in the
cabinet, continue with Step 3. If the built-in oven is not
installed into the cabinet, go to Step 5.
3. Use a Philips screwdriver to remove the #8-14 x1" screws
fastening the oven to the cabinet. Use a flat-blade screwdriver
to remove the grommets from the mounting rail hole by
inserting the screwdriver into the grommet and giving a
clockwise ¼ turn.
A
B
C
A. Mounting rail
B. Mounting rail hole
C. Grommet

INSTALLATION INSTRUCTIONS

Install Side Trim Cover Kit

WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
4. Using 2 or more people, pull the oven 1" (2.5 cm) out of the
cabinet cutout. Use the oven opening as an area to grip.
NOTE: Pull against the seal area of the oven front frame when
lifting the oven out of the cabinet. Do not pull against the
outside edges.
5. Remove the lower screw from each side of the control panel.
Tilt the control panel out enough to insert the left and right
side trim covers behind the control panel. Align the side trim
cover to the top and side of the mounting rail.
A
B
C
D
E
Right side rear view shown
A. Control panel
B. Mounting rail top
C. Lower screw
D. Right side trim cover
E. Mounting rail side
3