Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Required
Phillips screwdriver
⁹⁄₁₆" (14 mm) open-end
wrench (for leveling leg
locknuts)
Parts Supplied
Console
Screws (2)
Location Requirements
Your laundry tower can be installed freestanding or between your
washer and dryer. Proper installation is your responsibility.
Installation Clearances
The location must be large enough to allow the drawers to be
fully opened.
The console is an optional feature of your laundry tower. It allows
you to match the style of your laundry tower to that of a top-
loading washer, and it provides additional storage space.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
laundry tower.
Failure to do so can result in back or other injury.
1. Situate the laundry tower near its final location. Open the
drawers to remove any contents stored inside.
2
INSTALLATION REQUIREMENTS
Level
Measuring tape
Brackets (2)
A
B
A. Console
B. Bracket
INSTALLATION INSTRUCTIONS
Install the Console (optional)
When you are installing your laundry tower between or next to
your washer and dryer, a spacing of 1" (2.5 cm) on the sides of
the laundry tower is recommended to reduce noise transfer.
Additional spacing should be considered for ease of
installation and servicing.
Laundry Tower Dimensions
40 ⁷⁄₈
"*
(103.8 cm)
†
36" - 38"
(91.4 -
96.5 cm)
¹⁄₂
43
"
(110.4 cm)
*Includes leveling feet
**Includes drawer front
†
Adjust the leveling feet to match the height of your washer and
dryer.
2. Using a Phillips screwdriver, remove the 2 outside screws
from the back of the laundry tower top panel and discard
them.
A. Outside screws
10"
(25.4 cm)
³⁄₄
25
"**
¹⁄₂
(65.4 cm)
13
"
(34.3 cm)
A
Publicité
Table des Matières
