Installation; Preparation Of The Hood For Installation - Viking MVLH636SS Guide D'utilisation, D'entretien Et D'installation

Installation

Preparation of the hood for installation:

Assembling the duct cover support bracket (3 parts):
The three parts should be fixed with 4 screws, the support
extension is adjustable and should correspond to the
internal width of the upper duct cover.
To facilitate the installation it is recommended to remove the
panel before installing the hood.
Attention! Keep both hands on the panel when
disassembling or reassembling it into place to prevent
it from falling and causing damage to persons or
property.
Disassembly:
- Pull the panel (FRONT SIDE) firmly down,
- Push the small lever, located in the right side of the panel,
to the left,
- Unhook it from the rear joints.
Assembling the hood's hooks:
a. Attach two brackets (one per side) to the upper side of
the motor housing using 8 screws (4 per bracket).
b. Attach 2 hooks (one on each side) using 4 screws (2 on
each hook).
9