Replacing The Light Bulb; Charcoal Filter - Viking MVLH636SS Guide D'utilisation, D'entretien Et D'installation

Replacing the light bulb

Disconnect the appliance from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down. Replace the old light bulb with the one of the
same type as specified in the feature label or near the light
lamp on the hood.
1. Using a flat head screwdriver or equivalent tool, carefully
pry loose the light cover.
2. Remove the damaged light and replace it with a new one
(see the table below):
Lamp Power (W)
20
Voltage (V) Dimension (mm)
12 22 (Light Center
ILCOS D Code
(according IEC 61231)
HSGST/C/UB-20-12-G4-10/22
3. Reinstall the light cover. (it will snap shut).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
Socket
G4
10 (Diameter)
Length)

Charcoal Filter

It absorbs unpleasant odors caused by cooking.
The charcoal filter can be washed once every two months
(or when the filter saturation indication system – if
envisaged on the model in possession – indicates this
necessity) using hot water and a suitable detergent, or in a
dishwasher at 65°C (if the dishwasher is used, select the full
cycle function and leave dishes out).
Eliminate excess water without damaging the filter, then put
it in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
Assembly
Place the mat around the grease filter and fix it in place
using the devices provided.
Position the upper cap and fix it in place using the fixing pin.
To disassemble, perform the steps in the reverse order.
18