2.
Relocate the bike away from any equipment that
could potentially interrupt the radio frequency
signal, such as a DVD player or television, etc.
RPM or HR does not change
3.
Press 'MODE key' repeatedly to toggle between
SPEED (SPD), DISTANCE (DIST), TIME (TIME)
and CLOCK (CLK) values.
4.
Press and Hold 'SET key' repeatedly to clear past
measured value or go into setting and exit.
Cadence number jumps high or low
1.
Separate bikes that may be paired to the same
console code and are cross-talking, or simply run
transmitter pair stage again on the bike.
2.
Relocate the bike to a different part of the room,
away from any RF interference areas.
Heart Rate signal gets interrupted or drops out
3.
Ensure that there is a minimum distance of 36
inches between bikes.
4.
Verify that your chest strap is secure and that the
electrodes are making contact with your chest at all
times.
5.
Call our Customer Service department at
713-460-8188 for assistance.
CAUTION
EXTERNAL INTERFERENCE MAY BE CAUSED BY
OTHER ELECTRONIC DEVISES, SUCH AS:
NEARBY TELEVISIONS, STEREO EQUIPMENT,
SPEAKERS, ELECTRICAL WIRE CABLING, ETC. IF
YOU EXPERIENCE DISTURBANCES IN THE
CONSOLE DISPLAY TRY MOVING YOUR BIKE (S)
AWAY FROM POTENTIAL RF INTERFERENCE
AREAS.
WARRANTY
This is to certify that the Universal Group Cycling Monitor
is warranted by Direction Technology to be free of all
defects in materials and workmanship. This warranty
does not apply to any defect caused by negligence,
misuse, accident, alteration, improper maintenance, or
an 'act of God.' The Universal Group Cycling Monitor can
be adapted to almost any indoor cycling or spinning bike.
The Universal Group Cycling Monitor carries a one-year
warranty on the monitor, chest belt, and transmitter.
Batteries are not warranted. Contact our Customer
Service Department to report any problems.
When calling, please be prepared to provide the
customer service representative with the following
information: Your name, the serial number of the
inoperable monitor, and the date(s) of purchase. If