König Electronic HAV-IR20 Mode D'emploi page 10

Connect Mode
Connect Mode
Select [Connect] mode and then
choose [NEXT]
Proxy
Use Proxy
Select [Use Proxy] then choose [OK]
Network Status
Getting IP Address ...
Start connecting to the AP
2.4.3 Setting the Wi-Fi Connectivity by Wi-Fi Wizard
1. Insert a Wi-Fi USB adapter into the USB connector. (The Wi-Fi USB adapter is optional).
2. Then scroll up/down to [Network] and press ENTER/OK button.
3. Select [Connect] and switch [LAN] to [WLAN].
4. Select [Wizard] and then press ENTER/OK button.
5. Scroll up/down to an access point you want to connect, and then press ENTER/OK button.
6. If the access point that you are selecting is protected, press ENTER/OK button to select the
protected AP.
7. To input the encryption key, press UP/DOWN (or numbered key) button to change characters and
press LEFT/RIGHT button to shift.
8. Press ENTER/OK after you finish setting.
9. icon will show on the topside of the screen if the wireless setting is successful.
IP Setting
Infra IP Source
→
Select [IP Source] and then choose
Network Status
No
→
Config Wifi Module /
The system will save all configuration
Network
Connect
→
Wizard
Manual Setup
will show up if connection is
10
Dynamic
[NEXT]
LAN
>
>
successful