Electrical Connection; Door Reversibility; Ventilation Requirements; Installing The Appliance - ZANKER ZKK8023 Notice D'utilisation

Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C

Door reversibility

The door of the appliance
opens to the right. If you
want to open the door to
the left, do these steps be-
fore you install the appli-
ance:

Ventilation requirements

The airflow behind the
appliance must be suffi-
cient.
18
• Loosen the upper pin
and remove the
spacer.
• Remove the upper pin
and the door.
min.
50 mm
200 cm 2
min.
2
200 cm

Electrical connection

Before plugging in, ensure that the voltage and fre-
quency shown on the rating plate correspond to your
domestic power supply.
The appliance must be earthed. The power supply ca-
ble plug is provided with a contact for this purpose. If
the domestic power supply socket is not earthed, con-
nect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electri-
cian.
The manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
• Remove the door.
• Loosen the lower pin.

Installing the appliance

Caution! Make sure that the mains cable can
move freely.
Do the following steps:
On the opposite side:
• Install the lower pin.
• Install the door.
• Tighten the spacer and
tighten the upper pin.