Machine Information; Technical Specifications; Operating - VONROC CD506DC Traduction De La Notice Originale

Warning! This power tool produces an
electromagnetic field during operation.
This field may under some circumstances
interfere with active or passive medical
implants. To reduce the risk of serious or
fatal injury, we recommend persons with
medical implants to consult their physician
and the medical implant manufacturer
before operating this power tool.

2. MACHINE INFORMATION

Intended use
This screw driver is intended for driving in and
loosening screws.

TECHNICAL SPECIFICATIONS

Model No
Output of charger
Rechargeable Battery pack
Battery charging time
Chuck capacity
No load speed
Sound pressure level L
PA
Sound power level L
WA
Hand-arm vibration a
h
(screw driving without impact)
Vibration level
The vibration emission level stated in this instructi-
on manual has been measured in accordance with
a standardized test given in EN62841; it may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
WWW.VONROC.COM
CD506DC
5V DC Max. 1000mA
4V Li-ion 320 mAh
70-90 minutes
1/8" (4mm) hex
120 /min
39.5 dB(A) K=3 dB(A)
50.5 dB(A) K=3 dB(A)
0.149 m/s K=1.5 m/s
2 2
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-3.
1. Machine
2. Battery indication light
3. Work light button
4A. Counterclockwise switch
4B. Clockwise switch
5. Base cover
6. Work light
7. Bit holder
8. Screwdriver bit
9. Base
10. Charging socket

3. OPERATING

The machine must be charged before first
use.
Charging the machine (Fig. B)
In order to charge the machine, insert the small
micro-USB plug of the charger cable into the char-
ging socket (10) on the side of the machine (1).
Subsequently plug the large USB plug connector
into a USB outlet. The battery indication light (2)
will show the charging progress.
Fully charging the battery may take up to 70-90
minutes.
Fitting and removing drills or screwdriver bits (Fig. C)
The machine bit holder (7) is suitable for drills
and screwdriver bits with a standard 1/8" (4mm)
hexagonal shaft. To fit a screwdriver bit:
• Insert the screw driver bit (8) into the machine's
bit holder (7), it will be hold by a magnet.
• The screw driver bit can be removed by pulling
it out of the bit holder again.
Switching the machine on and off (Fig. A)
• Pressing the Counterclockwise switch (4A) will
activate the machine to loosen screws.
• Pressing the Clockwise switch (4B) will activate
the machine to tighten screws.
EN
7