Saeco Easy Mode D'emploi page 6

INSTALLATION / PRIMING
6
The messages displayed by the machine during operation are shown
on page 14.
Check that all components
are correctly placed.
See rating plate
Connect the plug placed at
the opposite side of the ca-
ble to an adequate socket.
Wait until a steady stream
of water fl ows out from the
nozzle.
Fill the coffee bean container
with coffee beans.
Move the ON/OFF switch to The machine is warming
"I" to turn on the machine. up; the light is fl ashing.
When the indicator lights
Turn the knob clockwise to
are fi xed, the machine is
stop the priming process.
ready for use.
Remove the container.
Important warning for using the "Aqua Prima Filter" can be found at
page 14.
The "Aqua Prima" fi lter can Fill the tank with fresh
be installed (see pg.13). water.
(Optional; it can be purcha-
sed separately).
Place a container under
the steam wand.
Put the plug into the soc-
ket placed on the machine
rear.
Turn the knob countercloc-
kwise to start priming the
machine.
Note: Prime the machine during initial set up, if the
machine has not been used for several days, after
refi lling the water tank, or any time the priming indi-
cator is steadily lit:
Check the dater on "Aqua Prima" fi lter; if fi lter is past its
date, replace it with a new one.