Förklaringar Till Menysystem - Husqvarna PP65 Manuel D'utilisation

Förklaringar till menysystem
CONNECT UNIT (1)
This image is shown if the power unit is not connected to
any tool. Connect the intended tool.
Electronic gear
When the intended tool is connected, the start screen (2)
is displayed. Press the menu button to start the settings
(3) and service (4) menus.
An illustration will be displayed when operating the
DM650 showing the selected electronic gear (23), current
rpm for mechanical gears 1 and 2, and recommended
bore diameter for these gears (24). The current feeder
load (25) of the drill will also be shown.
SETTINGS (3)
The "Settings" menu consists of sub-menus, which in turn
consist of a number of part menus.
RUN TIME (11)
Run time
TIME COUNTER (16)
On activation, a stop-watch is started to count the time the
tool is active.
CLEAR RUNTIME (17)
Used to reset the stop-watch.
CURRENT RUN TIME (18)
Current running time
TIME AND DATE (12)
Set time and date.
SET TIME (19)
State the current time.
SET DATE (20)
State the current date.
TIME FORMAT (21)
Select the required time format. Choose from between
the following options:
• 12 h
• 24 h
DATE FORMAT (22)
Select the required date format. Choose from between
the following options:
• YYYY-MM-DD
• YYYY/DD/MM
• DD/MM/YYYY
MENU SYSTEM
LANGUAGE (13)
Select the required display language.
FACTORY SETTING (15)
Resetting to factory defaults:
• Display language (English standard)
• Time format (12h standard)
• Date format (YYYY-MM-DD standard)
SERVICE (4)
The "Settings" menu consists of sub-menus, which in turn
consist of a number of part menus.
ERROR LOG (5)
List of errors (9)
TOTAL RUNTIME (6)
The machine's total operating time is displayed.
LINE VOLTAGE (7)
Connected input voltage of the machine.
PRODUCT INFO (8)
Information about the unit and the connected tool is
shown (10).
–
English 13