SEVERIN CY 7089 Mode D'emploi page 15

Cleaning the dust container
∙ Clean the dust container regularly, particularly under the following conditions:
∙ if the suction power seems to be reduced
∙ before storing the appliance for an extended period
∙ before sending the appliance to the service centre.
∙ Press the
button and remove the dust container.
∙ Turn the dust container lid anti-clockwise ( → ) and remove it.
∙ Unlock the dust container filter (turn anti-clockwise) and remove it. If necessary, clean the filter as indicated in the section
on "Cleaning or replacing the filters".
∙ Unlock the dust container insert (turn anti-clockwise) and remove it.
∙ Use the unfolded brush of the 2-in-1 tool to brush out the dust container insert. Do not use water on the insert!
∙ Rinse the dust container with water (use a mild detergent added to the water if necessary). Dry the dust container
thoroughly before putting it back into the appliance.
∙ Put the dust container insert back into the dust container and lock it in by turning clockwise.
∙ Place the dust container filter into the dust container with the black side facing downwards and lock it clockwise.
∙ Put the dust container lid on and lock it clockwise (
Cleaning or replacing the filter
∙ Clean the filter regularly, particularly under the following conditions:
∙ If suction power is lower than it should be
∙ before storing the appliance for an extended period, or
∙ before sending to the service centre.
∙ With household use, the filters must be replaced after 6 months.
Dust container filter:
∙ Take the filter out of the dust container (see the section on "Cleaning the dust container"). Remove the black insert.
∙ First, tap out the white filter, and then use the unfolded brush of the 2-in-1 tool to brush it out. Then tap out any loosened
dust residues again.
∙ The black foam insert in the filter can be washed, but must not be put in the dishwasher or washing machine.
∙ Rinse this insert thoroughly under running water.
∙ After cleaning, leave it to dry at room temperature for about 24 hours. Only put it back when it is completely dry.
Motor pre-filter:
∙ Take out the dust container and then take the motor pre-filter out of the appliance.
∙ The filter can be washed, but must not be put in the dishwasher or washing machine.
∙ Rinse the filter thoroughly under running water.
∙ After cleaning, leave it to dry at room temperature for about 24 hours. Only put it back when it is completely dry.
HEPA filter:
∙ Open the HEPA filter cover and take the filter out.
∙ First, tap out the filter, and then use the unfolded brush of the 2-in-1 tool to brush it out. Then tap out any loosened dust
residues again.
∙ Put the filter back in and close the cover.
Cleaning
∙ The housing and power cable may not be handled with liquids or immersed in liquids for reasons of electrical safety. Rub
housing with a slightly damp cloth and then dry.
∙ For cleaning, do not use any sharp or scouring cleansers or hard brushes.
Storing the appliance
∙ For easy storage, when not in use, the floor nozzle can be hooked into the parking hook below the power control.
/ → / ).
15