Initial Operation; Installation; Compressed Air Connection - Kuda B560PN Mode D'emploi

Josef Kihlberg B560PN
KUDA PACKAGING
5

5.1 INSTALLATION

The bottom stapler is delivered with the rear foot dis-
assambled. Assemble as following:
1. Remove the bottom stapler and the rear foot from
the carton.
2. Assemble the rear foot according to Fig. 3.
Tighten the two screws, (Fig. 3/1).
3. Place the bottom stapler on level, firm and clean-
working ground.
Lay the compressed air hose so that
there is no risk of tripping over it.

5.2 COMPRESSED AIR CONNECTION

Properly prepared compressed air is essen-
tial for troublefree operation of the bottom
stapler. This can only be ensured by a reliably functio-
ning maintenance unit, consisting of water separator,
pressure reducing valve with pressure gauge.
The internal diameter of the pipe should be at least
10 mm ( / ").
3
8
The bottom stapler doesn´t need any lubrication.
Connect and adjust the air pressure to the lowest
possible, approx. 5,0 bars (72 psi), which clinch the
staples correctly.
Never exceed the maximum permitted air
pressure of 8 bar (110 psi). The maximum
supply pressure is 8 Bar (110 psi).
Low air pressure will give low mainte-
nance costs!
SERVIS A NAHRADNÍ DÍLY
6
www.kuda-packaging.com

INITIAL OPERATION

Fig. 3
+420 607 237 237
info@kuda-packaging.com
1
servis@josef-kihlberg.eu
06.14