Trouble Shooting; Elimination - Kuda B560PN Mode D'emploi

KUDA PACKAGING
8
Before carrying out trouble shooting
on the bottom stapler always first
disconnect it from the air supply.
FAULT
Staples are not fed properly
Staples are deformed when inserted
Noise level is too high
The carton is damaged by the stapling head
The carton is not pressed together properly
Removing a staple which has got stuck
SERVIS A NAHRADNÍ DÍLY
06.14
www.kuda-packaging.com

TROUBLE SHOOTING

– Check if the right type of staples is used.
Always use Josef Kihlberg original staples.
– Check if the feeder spring is not defective. If
necessary replace.
– Check if the staple pusher is not defective. If
necessary replace.
– Clean the staple track.
– Check return spring in the stapling head. If
necessary replace.
– Check if stapling head bearing has no play (refer
to chapter 7.4).
– Check if anvil is properly centered. (refer to chap-
ter 7.5).
Check if driver is not damaged. If necessary
replace.
– Check if the staple channel is clean.
– Check if the air pressure is correct, (5 bar/70 psi).
– Check if the stroke speed is not unnecessarly
high.
– Check if the air pressure is correct, (5 bar/70 psi).
– Check if the stroke speed is not unnecessarly
high.
– Check if the length of piston rod is adjusted pro-
perly. If necessary adjust.
– Refer to chapter 7.3.
+420 607 237 237
Josef Kihlberg B560PN
info@kuda-packaging.com

ELIMINATION

servis@josef-kihlberg.eu
13