Kruger AIRSEC 75 Mode D'emploi page 18

Starting the machine
Maintenance
Direct water drainage
Cleaning
• Close doors and windows
• Insert mains plug
• Check correct positioning of water tank
• Set the hydrostat switch to the desired setting (usually, the
NORMAL position)
The machine works automatically, i.e. as soon as the level of dry-
ness set on the controller is reached, the dehumidifier switches
off and only starts working again when the humidity level rises.
We recommend that you fit a hygrometer in the room in order to
check the humidity levels. If the humidity level is too high, turn
the hygrostat controller to the right; if the humidity is too low,
turn the controller to the left.
When the water tank is full, the unit switches off automatically
and the indicator light on the front of the machine is illuminated.
• Turn hygrostat controller to 'O'
• Take hold of the tank with both hands and remove carefully
• Empty tank (do not re-insert half full)
• Replace tank correctly
• Reset hygrostat controller to previous position
If required, the collected water can be drained directly.
• Remove water tank (store for possible future use)
• Attach / " drain plug to the water collector (extras)
3
4
• Attach hose to plug
• Place the other end of the hose in a waste pipe
The moveable parts of this unit are hermetically sealed. The fan
motor bearings are provided with lifetime lubrication and are
therefore maintenance-free.
• Wipe the housing with a damp cloth without using a cleaning
agent
• Remove the air filter at the back of the machine by gently
pressing inward at the positions marked by the arrows
• Lightly brush the air filter with a brush and rinse out in tepid
water
• Clean activated carbon filter – if used – with vacuum cleaner
(do not use water).
• Wipe down the coil with a damp cloth without using a clea-
ning agent
• If the inside of the machine becomes particularly dirty, use
compressed air or vacuum cleaner to clean it