Safety Instructions; Transport And Storage - Victron energy Skylla-IP44 12/60 Manuel D'utilisation

1. SAFETY INSTRUCTIONS

1.1. General
● Please read the documentation supplied with this product first, so that you are familiar with the safety signs and directions
before using the product.
● This product is designed and tested in accordance with international standards. The equipment should be used for the
designated application only.
● WARNING: danger of electric shock
The product is used in combination with a permanent energy source (battery). Even if the equipment is switched off, a
dangerous electrical voltage may still be present at the input and/or output terminals. Always disconnect the AC power and the
battery before performing maintenance.
● The product contains no internal user-serviceable parts. Do not remove the front panel unless the mains and the battery are
disconnected. Do not put the product into operation unless all panels are fitted. All maintenance should be performed by
qualified personnel.
● Never use the product at sites where gas or dust explosions could occur. Refer to the specifications provided by the
manufacturer of the battery to ensure that the battery is suitable for use with this product. The battery manufacturer's safety
instructions should always be observed.
● WARNING: do not lift heavy objects unassisted.
1.2. Installation
● Read the installation instructions before commencing installation activities.
● This product is a safety class I device (supplied with a ground terminal for safety purposes). Its AC input and/or output
terminals must be provided with uninterruptible grounding for safety purposes. An additional grounding point is
located on the outside of the product. If it can be assumed that the grounding protection is damaged, the product should be
taken out of operation and prevented from accidentally being put into operation again; contact qualified maintenance personnel.
● Ensure that the connection cables are provided with fuses and circuit breakers. Never replace a protective device by a
component of a different type. Refer to the manual for the correct part.
● Check before switching the device on whether the available voltage source conforms to the configuration settings of the
product as described in the manual.
● Ensure that the equipment is used under the correct operating conditions. Never operate it in a wet or dusty environment.
● Ensure that there is always sufficient free space around the product for ventilation, and that ventilation openings are not
blocked.
● Install the product in a heatproof environment. Ensure therefore that there are no chemicals, plastic parts, curtains or other
textiles, etc. in the immediate vicinity of the equipment.

1.3. Transport and storage

● During storage or transport of the product, ensure that the mains supply and battery cables are disconnected.
● No liability can be accepted for damage in transit if the equipment is not transported in its original packaging.
● Store the product in a dry environment; the storage temperature should range from –20°C to 60°C.
● Refer to the battery manufacturer's manual for information on transport, storage, charging, recharging and disposal of the
battery.
3