Hand Blender - SEVERIN SM 3726 Mode D'emploi

Dear Customer
Before using the appliance, the user should
read the following instructions carefully.
Familiarisation
1. Power cord with plug
2. Hanging loop
3. Operating button I
4. Operating button II
5. Drive unit
6. Blender unit
7. Blade unit
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the blender.This product
complies with all binding CE labelling
directives.
Important safety instructions
●
Before the appliance is used, the main
body as well as any attachment fitted
should be checked thoroughly for any
defects. Should the appliance, for
instance, have been dropped onto a hard
surface, it must not be used any longer:
even invisible damage may have adverse
effects on the operational safety of the
appliance.
●
The power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
●
This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
●
Children should be supervised to ensure
that they do not play with the appliance.

Hand Blender

●
Caution: Keep any packaging materials
well away from children, as they are a
potential source of danger e.g. from
suffocation.
●
Do not allow the unit or its power cord to
touch hot surfaces or to come into
contact with any heat sources.
●
To prevent damage to the appliance, do
not attempt to blend hot liquids.
●
Always switch the appliance off and
remove the plug from the wall socket
before fitting, removing or cleaning the
blender unit.
The blade is extremely sharp. To prevent
injuries, take special care when handling
these parts.
After switching off, always wait until the
motor has come to a complete standstill.
Do not touch any moving parts.
●
Always remove the plug from the wall
socket after use, and also
- in case of any malfunction
- during cleaning of the appliance.
●
During operation, the unit should be
placed on a scratch-resistant surface.
●
No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
●
This appliance is intended for domestic
use only and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The addresses can be found in the
appendix to this manual.
Before using for the first time
- Before the appliance is used for the first
time, all detachable parts must be
thoroughly cleaned as described in the
section General Care and Cleaning.
7