FujiFilm TS-X 1440 Mode D'emploi page 18

Using the Binoculars
1
Rotate the battery-chamber latch to the left, remove the battery chamber,
and load the batteries. Reinsert the battery chamber and latch it by rotat-
ing the latch to the right.
2
Adjust the eye height by rotating the eyecups. Retract the eyecups if you
wear glasses and extend them if you do not.
3
Press the power switch. The system will start up and the power LED will
light. If the power LED fl ashes, the batteries are low and must be replaced.
4
Press the image stabilizer switch. The image stabilizer will turn on and the
image stabilizer LED will light.
5
With your eyes to the binoculars, adjust the eyepiece width until the views
in the right and left eyepieces overlap in a single circle.
6
Looking through the left eyepiece with your left eye, rotate the focus con-
trol until your target is in focus. Then, looking through the right eyepiece
with your right eye but without rotating the focus control, rotate the di-
opter adjustment control until your target is in focus. Finally, confi rm that
your target is still in focus when you look through the eyepiece with both
eyes.
7
When you have fi nished using the binoculars, press the image stabilizer
switch to deactivate the image stabilizer and then press the power switch
to turn the product off .
If the LEDs fl ash alternately, a system error has occurred. Turn
the product off , remove and replace the battery chamber, and
d
CAUTION
turn the product on; if this does not resolve the issue, contact
the original retailer.
EN-9
ENGLISH