Description Of The Device - Stylies ORION Mode D'emploi

Congratulations! You have just become the proud owner of the extraordinary Stylies Evap 420
Orion humidiier. You are sure to get a lot of pleasure from this device and it will improve the
air quality of your rooms.
As is the case for all electrical household devices, special caution is required when using this
humidiier in order for injuries, ire damage and damage to the device to be avoided. Please read
through this instruction manual carefully before you use it for the irst time, and adhere to the
safety guidelines on the device itself.

DESCRIPTION OF THE DEVICE

The device consists of the following main components:
1. Power cable for power supply
2. Upper housing
3. Cable compartment
4. Lower housing (Water tank)
5. Fragrance tray
6. On/of switch
7. Button for selecting the power setting, 1 or 2
8. Hygrostat button (air humidity adjustment)
9. Water illing opening with indication of max. water level
10. Vaporiser cartridges (2 pieces)
11. Ionic Silver Cube™
12. LED for operation (power on)
13. LED hygrostat (5) 40% - continuous operation
14. LED power setting (1 LED economy, 2 LEDs standard)
15. LED no water
FIRST USE / OPERATION
1. Please note: Never transport the device when it is illed with water and when upper part
(2) is attached. Otherwise water may splash into the upper part and stop the electronics
from working correctly.
2. For this reason, base (4) of the Stylies Evap 420 Orion humidiier should initially be illed
with water and placed in a suitable location separately. Alternatively, the device can initially
be positioned and then illed through water illing opening (9). Insert vaporiser cartridges
(10) into the "drawers".
3. When this base is in the desired position, place upper housing (2) back on the base. Plug
power cable (1) into the household power socket. Check that the housing is fastened se-
curely, as a safety contact prevents operation if the device is open.
4. Switch on the Stylies Evap 420 Orion using on/of switch (6). The desired power setting
can be selected using power setting button 1 or 2 (7).
5. The desired air humidity can be selected using hygrostat button (8), from 1 LED (low hu-
midity) to 5 LEDs (high humidity). For example, if only 1 LED is lit, the device switches itself
of at a relative humidity of approx. 35%, and only starts operating again when the humidity
falls below the 35% mark. We recommend a medium setting (in the comfort zone) for an
optimal air humidity of around 40-60%.
English
7